The attach a deck is a simple deck ledger mounting system that stands the ledger off the wall eliminating the need for flashing that s the big benefit but there are other features i like.
Ledger over siding.
In order to install the ledger board you usually need to remove the house s siding.
Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.
The following steps will explain an easy method of removing the lap siding and attaching a ledger board.
Then cut away the siding.
Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Instead cut off a section of siding so ledger can be in complete contact with house.
The ledger board is a horizontal framing member usually two by 10 or two by 12 lumber that supports one side of a deck and attaches flat to the wall of a house after removing a section of siding.
I want to attach the ledger board directly into the hardiboard siding of the garage with lag screws using washers as spacers for drainage between the ledger and the siding.
The wall leg is at least 7 in.
Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.
In the long run cutting into the siding and the exterior foam to install the ledger may be more work than installing the additional footings posts and beam needed for a freestanding deck.
Here are the steps to take when installing a ledger on a home with siding.
These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.
This may seem excessively tall but is needed in order for the water resistive barrier wrb and siding to overlap the top.
Start by making an outline on the siding where you want to position the ledger board.
After the ledger is installed a second strip of membrane tape is applied over the top of the ledger and about 1 2 in.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
Attach a deck can be used to mount ledgers on new homes and retrofit decks over siding on existing homes the system is tested by an engineering service the installation is simple and fast lag screws.
It only weighs 100 pounds it is a ledger board a front plate and eight 2x4 rafters sitting on two 4x4 posts.
