Kia Blind Spot Detection Not Working

If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized kia dealer and have the system checked.

Kia blind spot detection not working.

If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized k900 kia dealer and have the system checked. Service bulletin tsbele154 states that the blind spot collision warning malfunctions with a dtc c270254. I was driving to work and the warning light came on blind spot radar detector blocked. Be careful when removing the blind spot detection unit.

If the system does not work properly a warning message will appear and the light on the switch will turn off. Again the company chose not to discuss vehicle speed control systems through the manufacturer communications. Remove the rear bumper. Remove the foreign matter on the rear bumper.

Remove the bsd assembly a after loosening the mounting nuts. Remove the foreign matter on the rear bumper. If the system does not work properly a warning message will appear and the light on the switch will turn off. I m in northern california and was in fog mist by the coast at a standstill on the freeway due to an accident.

When removing the bsd unit be careful not to damage the bracket of bsd. They did however release another notice regarding other advanced safety systems which are just as important. If you found any problem in the bsd unit bracket or nut tightening correct the problem or replace the component. Disconnect the bsd connector a from the bsd unit.

When i shut the car off it went off. Of course the blind spot alarm does not alarm if you don t signal for a lane change. If a failure code is displayed or a warning lamp turns on even after performing bsd radar correction 5 times replace the bsd unit. The bracket may break off from the bumper.

Once i got moving the light remained on until i got to work.