Kenmore In Door Ice Maker Troubleshooting

As the auger rotates it pushes the ice toward the dispenser door and down the chute.

Kenmore in door ice maker troubleshooting.

Flush the lines with a solution of one part vinegar and one part water. I m assuming someone actually turned it on. To determine if the door switch is defective use a. Check your ice maker unit and make sure it s level.

Check the water lines in the back of the refrigerator to see if there is a visible kink or clog from the hard water that flows from the house line system. Make sure it s aligned correctly with the water funnel. Remove the ice bin. The door switch turns off the ice and water dispenser when the refrigerator door is open.

If the auger is defective it won t be abl e to push the ice out of the dispenser. Grip the handle at the bottom of the ice bin and pull it up and out of the ice compartment housing. I need to know how to fix an ice maker on a kenmore refrigerator. If the door switch fails the dispenser will not turn on.

If the door switch does not have continuity when activated replace it. Refer to the installation manual for additional help with this step if needed. Perhaps your ice maker is making ice but it s leaking water in the freezer or leaking onto the floor. Check your refrigerator and make sure it s perfectly level.

If someone turned it off i have a different pr. If the auger is broken replace it. If the water pressure in your area is relatively low make sure that you use a thinner hose to connect the ice maker to the water supply. Troubleshooting kenmore ice maker not working a faulty inlet valve may cause significant problems by delivering insufficient water.

If the refrigerator ice maker is not working the door switch might be defective. Check the fill cup. If the door switch fails the dispenser will not turn on. Multimeter to test it for continuity.

If your icemaker module does not work correctly it will not eject ice cubes. In order for the kenmore elite ice maker to operate properly the water pressure coming from the faucet should be 120 psi at the very least. Please verify whether your house s. In this case you must gently dismantle.

A kenmore ice maker that is not filling with water may have a frozen or clogged water line. When the freezer door is opened the freezer door switch does two things it turns on the light in the freezer and turns off the ice maker and dispenser. Check the auger to determine if it is broken or if it is disconnected from the auger motor. The switch can be checked for continuity with an ohm meter.

Check the water supply line for damage pinching or kinks.